Skip to content

How Limescale Forms Inside a Machine

Reviewed on November 19, 2026

Scale doesn't come from dirt. It comes from minerals that were dissolved in the water and then stopped being dissolved. Heating the water, which drives dissolved gas out of it, can tip them over.

What the deposit is

Limescale is a hard, chalky deposit, consisting mainly of calcium carbonate.1 Wikipedia says calcium and magnesium carbonates tend to be deposited as off-white solids on the inside surfaces of pipes and heat exchangers.2 A heat exchanger is any part that moves heat from one place to another, and a boiler wall is one.

The color can vary. Iron compounds give reddish browns.1

How it forms

Hard water contains calcium bicarbonate or similar ions. Wikipedia says heating water alone does not cause calcium carbonate to precipitate. Instead there is an equilibrium between dissolved calcium bicarbonate and dissolved calcium carbonate, and when dissolved carbon dioxide gas comes out of the water, calcium carbonate precipitates.1 It names the main driver in pipes as the exsolution of gas.1 The alkalinity page covers the bicarbonate side.

How scale builds up with each fillFresh hard water enters the boilerHeat drives dissolved gas outCalcium carbonate settles on surfacesNext refill adds more to the layer
The cycle repeats every time fresh water is added and heated.

It doesn't stop after one fill. As new cold water with dissolved calcium carbonate and bicarbonate is added and heated, the process continues.1 A machine that makes drinks every day gets a fresh batch of minerals every time.

Not all hardness behaves this way. Permanent hardness is generally difficult to remove by boiling.2 Hardness doesn't act the same way in every water, which is one reason Water Hardness Explained calls a single number rough.

What it does

Two effects matter in a machine. The first is flow. The second is heat.

Limescale build-up inside a pipe reduces both liquid flow through the pipe and thermal conduction from the liquid to the outer pipe shell.1 The EPA adds that scale on hot water pipes, boilers and heat exchangers can restrict or even block water flow.3

Why descaling needs care

Wikipedia says strongly acidic descaling agents are usually corrosive to the eyes and skin, and that appropriate protection such as rubber gloves and plastic aprons should be used.4 That's why the label matters. Use the product your maker names, follow its label, wear protection such as gloves, and never mix descaling products or cleaners.

Steam boilers add a wrinkle. Wikipedia says descaling steam boilers, such as those in espresso machines, can be difficult. The boilers do not fill completely, so the descaling agent is unable to reach the top of the boiler. If that happens, the device's safety valves, probes, and pressure sensors may not be cleared of limescale.4

Which is a good reason not to improvise. Follow the manual for your model, and never open a machine while it's under pressure or bypass a safety feature to get at scale.

Timing also depends on the machine. One maker's FAQ tells owners of its machine to wait for the descale warning.5 That's one model's advice, so check your own manual. Finding it is covered in your machine's manual.

What you can control

You can find out how hard your water is, see what the maker says, and then decide on treatment. Filter Pitchers and Cartridges Compared covers what filters change.

Where the facts come from

  1. Limescale, Wikipedia
  2. Hard water, Wikipedia
  3. Secondary Drinking Water Standards - Guidance for Nuisance Chemicals, U.S. Environmental Protection Agency
  4. Descaling agent, Wikipedia
  5. User manual and frequently asked questions ESSENTIAL, Tefal